My first stab at making a 20 sided die, it was definitely a challenge. The geometry of a d20 is definitely not CAD friendly but I stuck with it and here they are! I wanted to make something that would look at home being tossed across a table in a bar on an asteroid or thrown to choose the fate of a galactic pirate about to walk the plank.

Available sanded, painted, weathered and clear coated by yours truly or in raw resin form so you can decorate them as you see fit!(I would heavily recommend clear coating them after paint to preserve your work) I have run the ones I paint through a series of torture tests and the hold up fine against standard casual rolling(on a board game, dice mat, or felt line dice catcher. I would not recommend tossing these on concrete or against a brick wall if you’re going to get your hustle on.

Currently painted versions available in worn brass, copper and steel.

These are 3d printed in solid resin, measure 30mm across at the widest axis and weigh 0.35 ounces each.

Each order is for a single dice